SW 2K7 - Surface Trimming Problem

[arma1234]

My company just upgraded to 2k7 SP4 and now I am unable to use the surfacing trim or extend feature. When I try to do it it says it cannot do it because their is rebuild errors.

Completely stuck, 50% of my job is using surfaces and if I can't do this I am in deep water.

Any thoughts? Has anyone else run into this problem?

 

[Eltron]

I'm not finding any problems with the same service pack...at least not with the surface trim/extend commands anyways.

Dan

http://www.eltronresearch.com

 

[TheTick]

Is this on a new surface, or on one that worked in SW 2006?

 

[SBaugh]

Did you upgrade your SW06 to SW07 or did you do a new install?

If you upgraded, you shouldn't do that... you should always do a new install. For that not to work is a pretty major issue and would have had a .1 SP released by now to fix that. I think its something you might be doing or its your install. I would do one of 2 things... Reinstall as a new install and clean out the Registry or just try the alternative reinstall. - faq559-507

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

"If it's not broke, Don't fix it!"
faq731-376

 

[Theophilus]

Have you tried to trim with the Mutual option selected? Can you trim ANY surfaces (even if you create some surfaces to test the feature with)?



Jeff Mowry

http://www.industrialdesignhaus.com

Reason trumps all. And awe transcends reason.