SW 2006 Mirrored parts lose faces

[Kent0119]

When I modify almost any part in an assembly I get rebuild errors due to mirrored parts lossing references to faces.
The modification can be to a part in the main assembly or in a sub-assembly and the errors will show up in all assemblies with mirrored parts.

Talking to tech help has showed that this is a SW issue, not operator or hardware. A service pack request has been issued(#279672) and should be out with the next service pack(two months ?). Untill then I will stick to SW 2005.

I am working on a Dell Precision 370 workstation with Intel Pentiun 4 3.2 Ghz, 2 Mb Ram, NVIDIA Quadro FX 3400, XP Professional, SW 2006 clean install.

 

[SBaugh]

So are you asking a question or telling us?

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

faq731-376

 

[Theophilus]

This thread was already brought up a day or two ago on this forum.


Jeff Mowry

http://www.industrialdesignhaus.com

Reality is no respecter of good intentions.

 

[ctopher]

This thread was mirrored.

Chris
Sr. Mechanical Designer, CAD
SolidWorks 05 SP3.1 / PDMWorks 05
ctopher's home site (updated 06-21-05)
FAQ559-1100
FAQ559-716