Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Surface loft question ?

  • Thread starter Thread starter bianchi77
  • Start date Start date
B

bianchi77

Guest
Dear Members,
I tried to do surfacing loft, but only one side working

I attached the file so you can see it...

Thanks
 

Attachments

if you are trying to loft between both sketches then your sketches are not suitible

1. You may find it easier to split it into 4 sketches - otherwise you will need to use the selection manager to individually slect the splines (so 4 splines instead of 2 sketches)
2. They don't intersect. Even if I move your second sketch so the "dips" line up, they don't intersect which will result in a dodgy surface (if it manages to create one).

Ultimatley I would recommend doing the surface tutorial built into SolidWorks or watching a few videos to get an understanding of the fundamentals of surfacing.
 

Part and Inventory Search

Sponsor

Back
Top