Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

surface finish measurement, Ra

Status
Not open for further replies.
dho

dho

Mechanical
May 19, 2006
255
we have an internal sphere "groove" of .012 wide. it is made from reinforced Teflon.
it can not be Ra measured by profilometer. any way there? laser? vendor?
thanks.
 
Status
Not open for further replies.

Similar threads

Tmoose
  • Locked
  • Question
gross surface finish quantification
Replies
8
Views
421
MintJulep
M
O
  • Question
points to capture on a 3D measurement
Replies
4
Views
2K
IRstuff
IRstuff
Qcprick63
  • Locked
  • Question
surface finish?
Replies
3
Views
248
Qcprick63
Qcprick63
ASIT859
  • Locked
  • Question
FARO Cam2 - Straight Slot Surface Datum A, Flat Surface Datum B Inspection?
Replies
0
Views
770
ASIT859
ASIT859
Angus1
  • Locked
  • Question
Suggestions for 3D measurement scaning and comparing software / hardware
Replies
1
Views
329
tygerdawg
tygerdawg

Part and Inventory Search

Sponsor

Back
Top Bottom