Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Suppression by Expression Sketch Groups
- Thread starter MStrong
- Start date
JohnRBaker
Mechanical
If you're talking about the groups that you can create INSIDE of a sketch, the answer is NO.
These sketch objects, such as groups, are are known ONLY to the sketch and only while you're working in the sketch. Once you leave the Sketch task or editor, you lose the ability to even detect, let alone control those sketch groups.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
These sketch objects, such as groups, are are known ONLY to the sketch and only while you're working in the sketch. Once you leave the Sketch task or editor, you lose the ability to even detect, let alone control those sketch groups.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
TaylorAnderson
Mechanical
I don't believe this is possible yet, but it's a very cool idea. 
Taylor Anderson
NX Product Manager, Knowledge Reuse and NX Design
Product Engineering Software
Siemens Product Lifecycle Management Software Inc.
(Phoenix, Arizona)
Taylor Anderson
NX Product Manager, Knowledge Reuse and NX Design
Product Engineering Software
Siemens Product Lifecycle Management Software Inc.
(Phoenix, Arizona)
- Status