Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

support on bends

Status
Not open for further replies.
B.L.Smith

B.L.Smith

Mechanical
Joined
Jan 26, 2012
Messages
167
Location
TR
Dear friends,

I want to specify seven supports on 50D bend of a pipeline; but in CAESAR II, in bend section I can specify three supports in different angles. How can I specify more than 3 supports in different angles of a bend in the pipeline?
 
Sort by date Sort by votes
You just need to break the 50D into several smaller bend elements by identifying the tangent points in the offset geometry. I would recommend plotting it out first.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Green_APP
  • Locked
  • Question Question
Pipe Support Stiffness
Replies
0
Views
415
Green_APP
Green_APP
Mehr_1139
  • Locked
  • Question Question
How to find the resolution points for turbine check in CAESAR II based on NEMA SM23?
Replies
2
Views
425
Mehr_1139
Mehr_1139
Koussi
  • Locked
  • Question Question
Required Allowable Loads on Skid Tie-ins
Replies
0
Views
166
Koussi
Koussi
brvs2014
  • Locked
  • Question Question
How to enter support from an .text file
Replies
0
Views
179
brvs2014
brvs2014
Fatimah Awdhah
  • Locked
  • Question Question
can I active and deactive seismic load in one CAESAR II file?
Replies
1
Views
287
sjkji
sjkji

Part and Inventory Search

Sponsor

Back
Top