Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Support for house addition 1
- Thread starter kruzie
- Start date
ACtrafficengr
Civil/Environmental
Or an architect.
If you hire a PE or LA familiar with residential construction, they'll be able to guide you around many pitfalls. Depending on where you live, it could quite possibly be required to get your building permit.
------------------------------------------
"...students of traffic are beginning to realize the false economy of mechanically controlled traffic, and hand work by trained officers will again prevail."
Wm. Phelps Eno, ca. 1928
If you hire a PE or LA familiar with residential construction, they'll be able to guide you around many pitfalls. Depending on where you live, it could quite possibly be required to get your building permit.
------------------------------------------
"...students of traffic are beginning to realize the false economy of mechanically controlled traffic, and hand work by trained officers will again prevail."
Wm. Phelps Eno, ca. 1928
Wasdifferent
Civil/Environmental
kruzie,
Over the long haul, building without an Architect or an Engineer will cost you a lot of extra time and money. I hope that you don't learn this the hard way.
Best regards,
-Mike
Over the long haul, building without an Architect or an Engineer will cost you a lot of extra time and money. I hope that you don't learn this the hard way.
Best regards,
-Mike
-
1
- #5
Typical spacing for floor joists is 16" o.c.
The question should be, what is the maximum span. Usually local building departments should have standard span tables for common type V application.
Here is one from the City of Los Angeles:
The question should be, what is the maximum span. Usually local building departments should have standard span tables for common type V application.
Here is one from the City of Los Angeles:
The answer depends on what species of wood you are using and the grade. Where I live, we use southern yellow pine and if you consult the Southern Pine Council webpage( assuming a floor live load of 30 psf, 10 psf dead load and using a No. 3 grade, and a spacing of 16in O.C., the maximum length you would want to use is 12'-2". The Southern Pine Council design tables tend to be conservative, so I would round that up to 13 feet.
If you are using a different species of wood, consult your local lumber yard or Home Improvement store. they often have tables for the species of wood they sell and its applications.
If you are using a different species of wood, consult your local lumber yard or Home Improvement store. they often have tables for the species of wood they sell and its applications.
It depends on what you are trying to accomplish. If you want to tile the floor or put hardwood down, the tile industry as well as the wood flooring industry recommend 16" spacing with a 3/4" tongue and groove sturdifloor plywood.
If you want a less expensive option, you can cut some corners and go to 24" spacing and expect some floor shaking.
If you want a less expensive option, you can cut some corners and go to 24" spacing and expect some floor shaking.
If you are in Canada look it up in Part 9 of the Building Code.
Are you really a civil engineer?
Rick Kitson MBA P.Eng
Construction Project Management
From conception to completion
Are you really a civil engineer?
Rick Kitson MBA P.Eng
Construction Project Management
From conception to completion
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question