sufficient condition for FSRF of 1.0 in ASME VIII-2

[YuJie_PV]

hi all experts,

i am reading the following thread. and IdanPV quoted Hinnant's elaboration on what suffices to account for local notch effect.
Account for the Local Notch or Effect of the Weld - ASME Code Fatigue Analysis

In an FEA model, notch effect of the weld can only be accounted for if there is no singularity. In this case, the FSRF is 1.0 and the peak
alternating stress is taken directly from the FEA solution.--Chris Hinnant.

please allow me to nitpick his wording. i think only "no singularity" is not sufficient to allow for 1.0 of FSRF. surface condition of weld and weld quality (NDE) is also involved in the determination of FSRF. is my understanding correct?
Please comment.

Thanks in advance.

 

[IdanPV]

I suggest you to read this LinkedIn post, especially Mr. Seipp (AKA TGS 4) comments regarding the application of the FSRF.

A thin-walled hemispherical head is designed according to ASME VIII-1. | Idan Raz

A thin-walled hemispherical head is designed according to ASME VIII-1. For this vessel a nozzle is included in the top head. The full-penetration weld at the nozzle-to-head junction is sufficient to satisfy the area reinforcement requirements per the design Code. Since the vessel is subjected to...

www.linkedin.com

I don't think that the use of FSRF=1.0 is applicable in FEA, and FSRF shall be use or, as an alternative, using the Equivalent Structural Stress method.

 

[YuJie_PV]

IdanPV, thank for your post.