Sub Weldment Properties Question

[overkill04]

Hi All,

I created a large weldment part. Then I created a sub-weldment, then inserted into a new part in order to make a detail drawing of that sub-weldment. However when I created a drawing for my new sub-weldment, the weldment table doesn't have any description or length properties.

What is the best way to create a sub-weldment part, and then a cut list for that sub-weldment. Because right now it looks as though the best way to create sub-weldments is by bottom up design so you can maintain a cut list.





Specs, Intel Pentium M 2.16 Mhz
SW 2007 R2.2
1.5 Gb Ram
NVidia GE Force GO 6800 256Mb

 

[SBaugh]

Manully add the proeprties to the sub-weldment parts.

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

faq731-376

 

[overkill04]

That really sucks. Oh well, maybe the next release can have that capability.

Thanks for the quick response scott.

Specs, Intel Pentium M 2.16 Mhz
SW 2007 R2.2
1.5 Gb Ram
NVidia GE Force GO 6800 256Mb