Studio Spline - Reverse Endpoint Tangency? 1

[enexuser]

Hello,

Is it possible to reverse the tangency direction of the end of a studio spline, similar to the bridge curve command?
I'm beginning a spline curve by just clicking two endpoints in space, and then I want to add intermediate points.
But NX keeps assigning the tangency the wrong way when I click on the G1 constraint (or G2 for that matter.)
I've tried right-clicking the endpoint or messing with the 'specify constraint', but no joy so far.

Any insight on this?

Thanks,
Ben

Windows 7, NX 7.5 64 bit

 

[JohnRBaker]

Just double-click the end points and then double-click the appropriate arrowhead to change the direction, as shown in the attached video.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[enexuser]

Excellent - worked like a charm, John!
Thank you so much!

Ben