Studio spline faceting

[cobaltred]

I would like to know if there is a way to adjust or increase the resolution of a spline so that when you zoom in and look at it close
it would look smother and not the facets.I have a Nvidia quadro graphics card and I can adjust the surface faceting in NX but can not find for splines?


Thanks, Buddy

 

[cowski]

Perhaps adjusting the curve tolerance would help; Preferences -> Visualization -> Line tab, part settings section.

www.nxjournaling.com

 

[CADMANSOUTH]

One work around is:
After zooming in use the command View/Operation/Regenerate Work, or the hot key Ctrl+R

CADMANSOUTH
Cutting Tool Designer