Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Structural error limit
- Thread starter creixen
- Start date
Stringmaker
Mechanical
I think what you're asking is how to know or customize the value of the convergence tolerance. Default settings are typically good for this however if you feel the need to empt your own value you can use the CNVTOL command to do so.
- Status