D
dr_gallup
Guest
In the past (WF4), I was able to load a font called Strikethru which did exactly like it sounds, put a horizontal line through the middle of all the characters. This font is identical to the default font font with the strike through. We do this when we have a note or line in a table that is obsolete.
Now using Creo 2 it says that "Font strikethru.ndx.ndx can not be loaded". There are 3 Strikethru files in the Creo 2.0\Common Files\M100\text\usascii folder:
strikethru.fnt
strikethru.ndx
strikethru.src.
No strikethru.ndx.ndx.
I think these are the exact same files as in the proeWildfire4M170\text\usascii folder.
Did PTC change their font definition? I tried deleting the .ndx file thinking Creo could regenerate it but that did not work, it just complained that it did not exist.
Tried searching their help system, it was worthless as usual.
Now using Creo 2 it says that "Font strikethru.ndx.ndx can not be loaded". There are 3 Strikethru files in the Creo 2.0\Common Files\M100\text\usascii folder:
strikethru.fnt
strikethru.ndx
strikethru.src.
No strikethru.ndx.ndx.
I think these are the exact same files as in the proeWildfire4M170\text\usascii folder.
Did PTC change their font definition? I tried deleting the .ndx file thinking Creo could regenerate it but that did not work, it just complained that it did not exist.
Tried searching their help system, it was worthless as usual.
