Hi, I have an I-section built with shell elements, the cross section is at the X-Y plane, then the span is along Z direction, as shown in the attached image file. Loads applied on the top flange. I want to see the stresses generates on the WEB, which stresses output should I refer to? S11 or S22? please advise.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
stress
- Thread starter mambo5
- Start date
- Status
Similar threads
- Question
- Locked
- Question
- Question