Does anyone know how to get useful information from the stress linearization stress plot. How can the specific points be selected from the plot to show the intended stress. Can the displayed points be isolated? I am trying to separate the membrane and bending stress to compare against code allowables. (and how accurate are the linearized results?) Using WF4.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Stress Linearization
- Thread starter Bobfromoh
- Start date
- Status
Similar threads
- Chakkarabani Selvam
- PTC: Creo Simulate (Pro/E Mechanica)
- Chakkarabani Selvam
- PTC: Creo Simulate (Pro/E Mechanica)