Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Strenght Ratio is Zero but I have a Failurer Index

Status
Not open for further replies.
martin555

martin555

Aerospace
Joined
Nov 30, 2018
Messages
17
Location
US
Hi

I am running a FEMAP model of a simple laminate loaded in compression and tension.
I have PARAM SRCOMPS YES selected.
But when I output the strength ratio they are coming out as 0.
I had failure indices and strains but for some reason the SR =0
 
Status
Not open for further replies.

Similar threads

Rodolp21
  • Question Question
Forced response problem for a viscoelastic behavior law (MAT1 + MATVE)
Replies
1
Views
5K
Rodolp21
Rodolp21
brut3
  • Locked
  • Question Question
Model Meshing Issues
Replies
6
Views
3K
SWComposites
SWComposites
MrRogers1987
  • Locked
  • Question Question
FATAL MESSAGE 4129 Zero Area Element
Replies
1
Views
466
BlasMolero
BlasMolero
sivasooriyan
Reg. property groups in Autodesk Nastran
Replies
1
Views
8K
IRstuff
IRstuff
sivasooriyan
  • Question Question
Reg. property groups in Autodesk Nastran
Replies
0
Views
8K
sivasooriyan
sivasooriyan

Part and Inventory Search

Sponsor

Back
Top