Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

STP Export Error

Status
Not open for further replies.

adam1986

Industrial
Joined
Feb 28, 2013
Messages
56
Location
GB
NX 8.5.3.3

When exporting STP files i get the following error:

step203ug.exe - Entry Point Not Found

I have tried STP203 and STP214, both fail to export with the same error
I have also tried other parts....

I can however export these parts on a different machine, so im assuming its a local error?
The only other issue i can see is that Virus scanners think its malware, so put it in isolation, but i doubt thats the case in this instance.

Thanks in Advance

Adam
 
I think you should call GTAC on this. It's either a poor install, or something that Gtac can help you sort out.

Regards,
Tomas
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top