store layer structure

[weblinker]

Hello again


Does anybody know hwo to store the layer structure of a drwing with weblink?


Thank you very much for your assistance


Best Regards
Jurgen

 

[weblinker]

Hello again

Maybe it was not quite clear what I want to do. I hope the picture helps a little bit.
At the end of the picture there is highlighted "Status speichern" (store status). This is exactly what I want to do with weblink





View attachment 5623
Edited by: weblinker

 

[Arno]

Hi mister Weblinker,

have you found out if it's possible? i want to do the same with JLink, but i don't seem to find any method for it after some searching... it would be very usefull

 

[milindb]

In ProToolkit API ProLayerDisplaystatusSave() does the save task for layer status. You can look for similar API in weblink.


HTH.