I wish to connect two IMS4831E boards to drive two stepper motors on X and Y-axis with the help of party line command, I am following the instructions as in software and hardware manuals of IMS but both the boards are not communicating with each other and after sending command to one board the programme stucks there and not accepting any more commands.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Stepper Motor Party Line Command
- Thread starter Yaad77
- Start date
Similar threads
- Question
- Question