bongoman
Mechanical
- Sep 14, 2006
- 78
NX 9.0.2.5 Fixed Contour - Area Mill the 'stepover' column in the operation navigator does not update when
changing stepover type or amount however it seems to work ok in surface area drive method. This column updates fine
in NX 7.5. Anyone seen this, is it a bug. The operation changes the stepover properly it just not update the 'stepover' column.
Rick D
Win7 64 bit w/NX7.5 and NX9.0.2.5
Vericut 7.3
changing stepover type or amount however it seems to work ok in surface area drive method. This column updates fine
in NX 7.5. Anyone seen this, is it a bug. The operation changes the stepover properly it just not update the 'stepover' column.
Rick D
Win7 64 bit w/NX7.5 and NX9.0.2.5
Vericut 7.3
