Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Steel Plate bend
- Thread starter z1
- Start date
Normally rule of thumb is about 1/5 of thickness for 90 deg. In your case 0.3mm. nut since you bed less, you can cut this in half. How about you try o a scrap piece of metal? That would be the best method
there are some formulas on the net you can find that mimics elongatioin very well. I'll try to locate those I used in the past.
How about you try o a scrap piece of metal? That would be the best method by far
JL
there are some formulas on the net you can find that mimics elongatioin very well. I'll try to locate those I used in the past.
How about you try o a scrap piece of metal? That would be the best method by far
JL
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question