I wonder if anyone can help. I'm designing a stretch bender for producing a car door window glass channel. I can't get any info out of the end user on the steel to be used. Has anyone any idea of what steel is used in glass channels and what its yield stress is likely to be. It's already rolled into a U - section. I suspect it could be something like CR1. I'm working on 530N/mm^2 at the moment. Thanks in anticipation.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Steel for glass channel
- Thread starter Roachman
- Start date
MikeHalloran
Mechanical
Get a sample, bend it, and work the math.
JCW used to stock the stuff, but they've gone back to being a junkyard, or less, so your local junkyard may be your best source.
Mike Halloran
Pembroke Pines, FL, USA
JCW used to stock the stuff, but they've gone back to being a junkyard, or less, so your local junkyard may be your best source.
Mike Halloran
Pembroke Pines, FL, USA
- Status
Similar threads
- Question
- Question
