Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Steel Flywheel - Ring Gear Interference Fit

Status
Not open for further replies.

jbengine

Automotive
Jan 11, 2004
2
I am currently working on the design of a steel flywheel for a customer to replace the dual mass flywheel that is already on their vehicle.

Does anyone know what a 'standard' interference fit for holding a ring gear onto a steel flywheel should be?

Many thanks in advance for your help Guys!
 
Replies continue below

Recommended for you

Thanks for the reply Rod. I had looked at that post previously and had wondered if the level of interference would be different for steel/steel and steel/aluminium. The figures in that thread seem a good starting point though.

Once again many thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor