Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
STEAM TRAP OPERATION 3
- Thread starter ommuruga
- Start date
-
1
- #2
TLV, Armstrong, Spirac Sarco and Yarway all have very good booklets on steam trap operation, selection and troubleshooting. I'd check with your vendor and ask him for some information.
What is the problem you are seeing with this trap, what sort of equipment is it on or is this more of a general question? Bimetallics can be designed to either discharge the condensate at either close to saturation temperatures or subcooled a certain amount if I remember correctly and that makes a big difference in what you would see with a trap that is operating correctly versus one that has failed.
What is the problem you are seeing with this trap, what sort of equipment is it on or is this more of a general question? Bimetallics can be designed to either discharge the condensate at either close to saturation temperatures or subcooled a certain amount if I remember correctly and that makes a big difference in what you would see with a trap that is operating correctly versus one that has failed.
-
2
- #3
Go to this site
and click the link N101.pdf (under section Download Handbook .......) you will be delighted.
and click the link N101.pdf (under section Download Handbook .......) you will be delighted.
YOU CAN GO TO :
THEN, AT THE UPPER RIGHT SIDE CLICK THE "TRAP-A-WARE" TO DOWN LOAD THE FILE ,YOU WILL GET THE SIZING PROGRAM. CAUSSE THE SIZE IS ABOUT 53MB, NEED SOME TIME
THEN, AT THE UPPER RIGHT SIDE CLICK THE "TRAP-A-WARE" TO DOWN LOAD THE FILE ,YOU WILL GET THE SIZING PROGRAM. CAUSSE THE SIZE IS ABOUT 53MB, NEED SOME TIME
- Status
Similar threads
- Locked
- Question
