Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Steam flow nozzle design

Status
Not open for further replies.
brianle

brianle

Mechanical
Nov 4, 2006
23
In a steam flow nozzle in a 600,000 lb/hr steam line, would there typically be a hole (3/8" - 1/2" diameter) through the side of the nozzle down stream of the throat?

Thanks,

Brian
 
Status
Not open for further replies.

Similar threads

dbday
  • Locked
  • Question
Nozzle bore machining 1
Replies
5
Views
2K
r6155
r6155
IdanPV
  • Question
Nozzle to Shell Weld
Replies
11
Views
4K
DekDee
DekDee
RadiateurFou
  • Question
Buckling analysis of header/nozzle assembly
Replies
2
Views
2K
RadiateurFou
RadiateurFou
larry_s
  • Question
boiler steam accumulator
Replies
12
Views
5K
georgeverghese
georgeverghese
M L Kuselan
  • Locked
  • Question
PV Elite design Hub Type Self Reinforced Nozzle (SRN) with LIP
Replies
2
Views
1K
M L Kuselan
M L Kuselan

Part and Inventory Search

Sponsor

Back
Top Bottom