I am working on part names for a new line of products we are developing. Does anyone know where to find the standards or rule of thumb convention for doing so? Is this regulated or accepted by ASME or another organization where I could find standardized information? Thanks for any input you can give.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Standardized Part Naming Convention 1
- Thread starter vctech
- Start date
ASME Y14.100.
A lot of it is in a non mandatory appendix but there is a little in the main body.
Also ASME Y14.38 gives a list of standard abbreviations etc.
A lot of it is in a non mandatory appendix but there is a little in the main body.
Also ASME Y14.38 gives a list of standard abbreviations etc.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
-
1
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question
