Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Standard ID and OD of PH17-4 tubing

Status
Not open for further replies.
kkeenn

kkeenn

Mechanical
Joined
Nov 11, 2010
Messages
20
Location
US
I am looking for a catalog of standard ID and OD of 17-4 SS. The OD range should be from 3-20mm.

I have the sizes for other stainless alloys but cannot find one for 17-4. Any help would be appreciated.

Thanks.
 
Status
Not open for further replies.

Similar threads

WKTaylor
  • Question Question
The incredible evolution of the PGM-17 Thor Missile to Thor-Delta and finally Delta
Replies
1
Views
8K
dcascap
dcascap
Cj1234567
  • Locked
  • Question Question
Bend radii and Strength Knockdowns for tubing?
Replies
2
Views
550
WKTaylor
WKTaylor
Claudio_F84
  • Question Question
Fatigue justification of a thread bolt
Replies
4
Views
11K
WKTaylor
WKTaylor
O
  • Question Question
pressure drop test nitrogen instead of helium
Replies
15
Views
10K
WKTaylor
WKTaylor
WKTaylor
  • Question Question
Grim news... Trump's 2026 budget would slash NASA funding by 24% and its workforce by nearly one third
Replies
16
Views
21K
WKTaylor
WKTaylor

Part and Inventory Search

Sponsor

Back
Top