Stainless NDT spec 1

[RMPE]

Is there an ASTM or AWS spec for proper dye testing of 12 ga stainless sheet fusion welds? We're field assembling a continuous water tight gutter trough for a swimming pool.
I don't have any AWS codes other than 1.1. I believe 1.6 is for stainless. Thanks.

 

[Carburize]

I believe that ASTM E165-02 will cover your requirements.

 

[NDTLevel3]

ASTM 165 will explain penetrant inspection well enough to allow you to perform the inspection you are doing. I will suggest an additional technique typically used in these cases: if possible, apply the penetrant on one side and look for bleed out on the other. Bleed out indicates areas that will leak.
William E. Blum
Manager
NDT Consulting Group Inc.

http://www.ndt-cgi.com

wblum@ndt-cgi.com
USA 1-877-638-2441
Fax/Voice Mail 1-214-853-5131
Sweden 46-42-14 39 99

 

[RMPE]

Found it. Thanks for the tip. Just what I was thinking.