Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

stacked fractional dimensions in st4

Thread starter szappitello
Start date Jan 10, 2012

Status: Not open for further replies.

Jan 10, 2012

szappitello

Mechanical

relatively new to solid edge. i would like to have my fractional dimensions stacked. i know you can do it inside a text box, but i am not sure how to do it in a dimension. at first i thought it was a simple task, but i am begining to think it is not in the program yet.

thanks in advance