rmaki
Aerospace
- Oct 24, 2007
- 15
What is the calculation needed to do a Stack up Tolerance
Analysis.Never done it before.
I have a part in a "U" shape with a hole pattern of 20 holes
and a couple of slot on the sides.
Tolerance is off by .001" in one side of the hole pateern and on one slot.
Any ideas?
Thank you.
Analysis.Never done it before.
I have a part in a "U" shape with a hole pattern of 20 holes
and a couple of slot on the sides.
Tolerance is off by .001" in one side of the hole pateern and on one slot.
Any ideas?
Thank you.