ST4 no material table in assembly enviroment??

[JEMMERICH]

I used to use the material table in the assembly enviroment to automatically drive information into the draft.

For example, I would call out a casting number as the material.

It now looks like I can no longer do this in ST4 unless I am missing something. Any else run into this?

 

[beachcomber]

Have you just installed ST4?
If so did you save your old material table?

bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.

Where would we be without sat-nav?

 

[JEMMERICH]

It was installed recently.
I saved the old table and have access to it in the part and sheetmetal enviroments but I dont see a way to access it in the tabs or add it to the quick access toolbar.

 

[beachcomber]

I don't understand why you want to access it in that way, surely its just for setting the material in your part files.

bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.

Where would we be without sat-nav?