Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
st3 hole position
- Thread starter 4126
- Start date
beachcomber
Mechanical
What is your computer spec. ?
Is this in a single part or are you working in a big assembly?
It sounds like you don't have enough memory in the computer and its using the hard disc virtual memory, hence the disc activity.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
Is this in a single part or are you working in a big assembly?
It sounds like you don't have enough memory in the computer and its using the hard disc virtual memory, hence the disc activity.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
- Thread starter
- #3
beachcomber
Mechanical
Sorry, I never used sync mode so I've no idea what it could be, but post your computer spec just in case.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
- Thread starter
- #5
beachcomber
Mechanical
Sorry for the delay in replying - been really busy.
Your computer spec sound OK although I'm not sure about using a GeForce graphics card.
This isn't a card preferred for CAD so it could make a difference.
Other than that I can't really help.
Sorry.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
Your computer spec sound OK although I'm not sure about using a GeForce graphics card.
This isn't a card preferred for CAD so it could make a difference.
Other than that I can't really help.
Sorry.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
- Status
Similar threads
- Locked
- Helpful tip
- Locked
- Question