Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
SRI values for an aluminium door
- Thread starter BrianD
- Start date
Hi,
I don't think you'll find any data on roller doors since fabricants aren't that keen to test their doors. Try data for an aluminium sheet of the same tickness as a groove evaluation. That's what at best the door will give. There's however certainly many leakages. You can then set the sound reduction to max 20 dB for frequences over 1000Hz. That's far to be precise, but probably not that far from what you'll get.
OkdB
I don't think you'll find any data on roller doors since fabricants aren't that keen to test their doors. Try data for an aluminium sheet of the same tickness as a groove evaluation. That's what at best the door will give. There's however certainly many leakages. You can then set the sound reduction to max 20 dB for frequences over 1000Hz. That's far to be precise, but probably not that far from what you'll get.
OkdB
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question