I have recently been given the task of re-engineering a lead nut for a machine tool. The thread is a square section that doesn't seem to comform to any standard i am aware of or can find. The thread is Ø1.75" X .375" pitch, however the length of crown is not pitch/2. Any suggestions on a standard to follow?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Square thread standards
- Thread starter westonm
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question