Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Square shaft design 5

Status
Not open for further replies.

dejan95

Mechanical
Joined
Aug 24, 2020
Messages
60
Location
SI
Hello everybody,

I have a question about designing a square shaft. Picture bellows shows my shaft which is round. At the end (t highlighted part) I would like to make it squere to prevend turning of the part that is attached to it. (unfortunately I don't have enough room for a dowel or a pin).

So this part would probably be made with milling? How do I design it so the operator won't have any problem making this part.

Capture_xoduoy.png


Thank you in advance!
 
Could the shaft be threaded?
 
Are you working in solidworks? Or it is an another programm?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top