Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Square Flange Design

Status
Not open for further replies.
llls

llls

Mechanical
Joined
Nov 3, 2002
Messages
21
Location
AU
Hi I am looking at finding a standard that could be used for design of an atmospheric process vessel (tank) for SG>1 toxic/corrosive products. The vessel diameter is 3m or less and will be supported on four legs.
 
Sort by date Sort by votes
No, these flanges are part of the steel ducting system used to recover off gas from the steel furnace. The dimensions are in the range of 1500x 1700 to 2400 square. The ducting is of 12 mm plate and the proposed flange thickness is 22mm with full face gaskets.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Prometheus21
  • Locked
  • Question Question
O-ring groove design
Replies
4
Views
1K
Prometheus21
Prometheus21
Baraa Karam
  • Locked
  • Question Question
O-ring groove design
Replies
1
Views
349
hydtools
hydtools
bluepanasonic
  • Locked
  • Question Question
Looking for guidelines & best practices on water tight bolted joint design & validation
Replies
0
Views
423
bluepanasonic
bluepanasonic
PrecisionMan
  • Locked
  • Question Question
Static sealing- Bolted joint design
Replies
2
Views
401
desertfox
desertfox
Ahmed Zeid
  • Locked
  • Question Question
Thread design help
Replies
1
Views
262
506818
506818

Part and Inventory Search

Sponsor

Back
Top