Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Spur Gear Design 1

Status
Not open for further replies.

ApurvCurtis

Aerospace
Jun 10, 2019
1
I am using Custom 465 for spur gear train design.

Module = 0.8 mm
Max. Pitch Diameter is 50 mm.
Can somebody provide the Gear Test data for Custom 465 (Contact and Bending Strength)?? Or should I use the Fatigue data provided by the "Carpenter" Tech. Sheet ??

Thanks in Advance !!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor