Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Spring loaded level/handle

Status
Not open for further replies.

KKerr23

Mechanical
Joined
Jun 8, 2012
Messages
41
Location
US
I have a current design that I wish to use a spring loaded lever that can be pulled out in order to obtain different locking positions with a set pin. I know I have seen these types of levers used in other systems but my research has come empty trying to find a company that fabricates these. Are there any companies that do make spring loaded levers or is it something I will have to design from scratch?
 
Carr in St. Louis specializes in the weirdest clamps I have ever seen!!
 
I think Fairlane Products is the manufacturer that makes those handles in the reid supply link I gave.
 
It is similar to the products in those links, but those are mainly for lockling pins. What I am talking about is an actual lever where the handle is spring loaded so that you can pull the handle out to unlock and release to lock. My idea is to add a set pin to the side of this type of lever and use the set pin to lock into a set of teeth. I have seen these types of levers around but I have no clue who would make them.
 
Not like a hand brake. Like with a spring loaded pin you would pull up the handle to pull the pin out then release to lock it back into place. Instead of the pin locking into a hole, I am installing a set pin on the side of the base to align in a set of teeth
 
Like this?

1RLL7_AS01
 
Eh. Kind of like that. Instead of the clutch on the bottom of the lever, it would just be a matter of pulling the handle out axially wrt the shaft to adjust the position of the lever
 
Ergonomically/mechanically your proposal is likely to be tricky to get working satisfactorily. The Off axis torque on the sliding joint as the operator attempts to pull the handle along it will tend to casue it to bind. I have seen what you propose, but they use a knob not a handle, so there is no off axis torque.

Cheers

Greg Locock


New here? Try reading these, they might help FAQ731-376
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top