hello - sorry for the lame post but i would like to know if anyone has a chart or table for spotface diameters larger then m36 - my table only goes to m36 nuts - any help would be appreciated - right now i used the same distance from the nut points on the m36 to the spotface diameter o.d. - thank you again
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
spotface diameter for m42 nut
- Thread starter duk748
- Start date
Well then you're doing it wrong.
You'd theoretically need the distance across the 'nut points' plus the position tolerance (and clearance of the bolt in the hole/holes if deliberately over sized).
If you have the head information for the M42 you should be able to work it out.
You'd theoretically need the distance across the 'nut points' plus the position tolerance (and clearance of the bolt in the hole/holes if deliberately over sized).
If you have the head information for the M42 you should be able to work it out.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
- Thread starter
- #3
- Status
Similar threads
- Question
- Locked
- Question