Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Splitting curves
- Thread starter onefjef
- Start date
Hi,
I've circumvented this by using the Move function with copy to
place a straight line at intervalls. For an arc I use 'Rotate'
also with copy and then rotate by a certain step. When forming
a circle by segments the circle can be used for say a protrusion
SE will treat it as closed profile also the individual segments
are not manually connected to each other. The same applies to
the line segments (V19/Sp3)
dy
I've circumvented this by using the Move function with copy to
place a straight line at intervalls. For an arc I use 'Rotate'
also with copy and then rotate by a certain step. When forming
a circle by segments the circle can be used for say a protrusion
SE will treat it as closed profile also the individual segments
are not manually connected to each other. The same applies to
the line segments (V19/Sp3)
dy
- Status
Similar threads
