Solids and Meshes
Hi! Kitch02,
It depends on which entities you are selecting and which command you use with them.
Edgesurf is a mesh modelling technique or wireframing method (not solid) and requires four individual but touching entities in order to work.
So even if your single spline was still not closed it would not work, using Edgesurf.
There are other methods such as revsurf, tabsurf & rulesurf.
Each of these requires a slightly different approach.
The help files would be a good start to seeing how it’s done.
Have a look at an answer I posted here to one called ‘knabini’ titled ‘’how to run a profile along a curve’’, on the second page.
It might give you an insight into making meshes.
Solids are somewhat simpler I think.
Why everything using splines? You can use lines, polylines & arcs an’ stuff you know!
Good luck and let us know how you got on.
I’ve been using 2005 & 2006, but I know the edgesurf stuff works in 2004 as well.
I don’t know nuffink about 2007………yet!
There are answers about......
Regards
Stephen