Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

spin at center of the part

  • Thread starter Thread starter phoxeoy
  • Start date Start date
P

phoxeoy

Guest
I was hoping that somebody could tell me if it's possible to move the
center of xyz so when rotate my part it will rotate at the center. I
had to create some datums about 1.500 inches off the part and now my
spinning center is not in the center of my part.
 
In 2001.


View > Reorient > under Type select 'Preferences' > Point or vertex > pick a point for new location of spin center.


Charles
 
thank you. It's seems odd after all these years I have never ran across this issue before. Learn something everyday.
 
In 2001.


View > Reorient > under Type select 'Preferences' > Point or vertex > pick a point for new location of spin center.


Charles

But if you closed the model and reopened, it seems the spin center needs to be relocated...
 

Part and Inventory Search

Sponsor

Back
Top