Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
SPEED CONTROL for motors
- Thread starter Ludovic
- Start date
Before you go further and suspect the motor performance it's advisable to carry
out the followings:
-Disconnect the motor connection and test the controller it self to confirm
It’s operation, if the problem still occurring thin used analog signal (current
source 4 to 20 ma) and test controller, if the problem still then replace the
control card which used to firing the Thyristor.
By the way it happens with me 5 years ago and I follow the above and it works
out the followings:
-Disconnect the motor connection and test the controller it self to confirm
It’s operation, if the problem still occurring thin used analog signal (current
source 4 to 20 ma) and test controller, if the problem still then replace the
control card which used to firing the Thyristor.
By the way it happens with me 5 years ago and I follow the above and it works
- Status
Similar threads
- Locked
- Question
- Locked
- Question