Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Spectral density of complex vector using Welch

Status
Not open for further replies.
Shz713

Shz713

Structural
Joined
Aug 21, 2015
Messages
221
Location
AU
Hi all,

For two signals (one with double values and other with complex values), I obtained corresponding auto and cross spectral densities. When I plot the output (attached figure), cross spectral density is shown in negative region. I know I can take absolute of output, but I would like to know why the frequency peaks are upside down. Is this due to complex numbers?

Cheers,

Shoot for the Moon, even if U miss, U still land among Stars!
 
 http://files.engineering.com/getfile.aspx?folder=abe2c2b0-a063-4ab7-8654-090d9dd73ea7&file=Spectral_density.bmp
Status
Not open for further replies.

Similar threads

TEIF-RO
  • Locked
  • Question Question
obtaining a NORMALISED POWER SPECTRUM DENSITY
Replies
2
Views
862
IRstuff
IRstuff
Melad Saad
  • Locked
  • Question Question
Optimisation of Structural Analysis and Design of steel space structure using MATLAB
Replies
4
Views
985
IDS
IDS
SomptingGuy
  • Locked
  • Question Question
Are you using an old version?
Replies
3
Views
869
SomptingGuy
SomptingGuy
fakhteh
  • Locked
  • Question Question
correcting angels of polygon after inputting observed polygon angels in [dms] type (degree minute se
Replies
2
Views
846
Stick.
Stick.
margaritaklag
  • Locked
  • Question Question
Development of multivariable function
Replies
1
Views
282
IRstuff
IRstuff

Part and Inventory Search

Sponsor

Back
Top