Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Specifying Unified Thread Form Custom Threads

Status
Not open for further replies.
KENAT

KENAT

Mechanical
Joined
Jun 12, 2006
Messages
18,387
Location
US
I recently created a FAQ on this topic over in "Mechanical engineering other topics" and thought it might be of interest here too.

FAQ404-1480

Also, if anyone has any feedbacks on potential edits I'm open to suggestions.

KENAT, probably the least qualified checker you'll ever meet...
 
Status
Not open for further replies.

Similar threads

dthom0425
  • Locked
  • Question Question
Specifying ASME versions on drawings
Replies
4
Views
3K
supergee
supergee
ericscottf
  • Locked
  • Question Question
Proper GD&T for interrupted threads?
Replies
14
Views
1K
ericscottf
ericscottf
mackra
  • Locked
  • Question Question
ECO form: "IS" "WAS" order
Replies
4
Views
3K
drawoh
drawoh
MattEdwards
  • Locked
  • Question Question
Specifying the orientation of a dimension
Replies
19
Views
984
3DDave
3DDave
MechEnjoyer
  • Locked
  • Question Question
Specifying the average slope of a profile
Replies
3
Views
361
Burunduk
Burunduk

Part and Inventory Search

Sponsor

Back
Top