Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SP2 installation

Status
Not open for further replies.

alolesen

Mechanical
Jul 21, 2005
88
So, is anyone else having trouble installing SP2? It keeps asking for the installation source CD, in spit of the fact that I have the CD in my drive?
 
Replies continue below

Recommended for you

Specifically, it's looking for this file:

English_i386_SolidWorks.Msi
 
Did you install SW07 with the CDs or DVD?

Whichever you used, you must use the same when updating SPs.

[cheers]
 
I used the DVD but I had to go and find English_i386_SolidWorks.Msi on the DVD. The installer wouldn't find it on its own.
 
Just to clarify ... you used the DVD for the original install and for the update? Your OP stated that you had a CD in the drive when trying to update.



[cheers]
 
I used the DVD for the original install and tried both the DVD and CD for the update, with the same result.
 
I had no problem going from SP0 to SP1 to SP1.1 to SP2.

Do you have other computers at work/home to run comparison test on?

[cheers]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor