Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SP 3.0 problem

Status
Not open for further replies.
pegleg

pegleg

Mechanical
Oct 9, 2002
6
Good morning all,

Has anyone tried installing SP 3.0 on a Windows Installer seat and found that it looks for a file on the SW cd that doesn't exist?

[bomb]
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Been running since it came out no problem here.

You sure you have the correct install type?

95% of the time most people I here from, this is usually the case.

Regards,



Scott Baugh, CSWP [spin] [americanflag]
3DVision Technologies
faq731-376
When in doubt, always check the help
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

AF2023
  • Locked
  • Question
Problem with chamfering a tapped hole in Solidworks 5
Replies
15
Views
886
ASIT859
ASIT859
nia573
  • Locked
  • Question
Problem with Ordinate dimensions 1
Replies
11
Views
696
moon161
moon161
krishnaloks
  • Locked
  • Question
problem during compilation
Replies
0
Views
193
krishnaloks
krishnaloks
bjlasota
  • Locked
  • Question
Flat Pattern Problem, Orientation Problem, Viewing Problem. The day of Problems
Replies
3
Views
373
bjlasota
bjlasota
FireTruckBerserker
  • Locked
  • Question
Linking custom property to configuration specific dimension
Replies
1
Views
439
drawoh
drawoh

Part and Inventory Search

Sponsor

Back
Top Bottom