Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Solidworks Toolbox

Thread starter MachineSMMC
Start date Jan 16, 2006

Status: Not open for further replies.

Jan 16, 2006

MachineSMMC

Industrial

Good Morning

I have been adding a part description to screws as I have been using them. Now I would like to get rid of all of thoses descriptions. What is the easiest way top do this? I basicaly want to get back to the original tool box.

Thanks
Chris Tellers