K
kelvinb
Guest
im sure this is a simple fix, but for some reason i cannot figure it out. im breaking down drawings to use less material, and this specific part isnt doing what the rest have done, because its not a simple design.
this is the part im doing now. the area on top, and the right side will obviously not adjust in relation to the rest of the part because of the points.
this is the left side after i make it the dimension i want, and its fine. the other side will not do it.
what do i need to do to make this work?
this is the part im doing now. the area on top, and the right side will obviously not adjust in relation to the rest of the part because of the points.
this is the left side after i make it the dimension i want, and its fine. the other side will not do it.
what do i need to do to make this work?
