SOLIDWORKS HOLE TABLE

[CADGemini]

HI THERE EVERYONE,

I NEED TO KNOW IF IT IS POSSIBLE TO ADD TOLERANCE DIMENSIONS TO HOLE TABLES AND IN THE BOM'S IN SOLIDWORKS 2004. I HAVE SP3.0 LOADED ALSO. I HAVE BEEN TRYING FOR ABOUT 3 HOURS NOW AND CANNOT SEEM TO FIGURE IT OUT. ANY HELP WITH THIS WOULD BE GREATLY APPRECIATED. THANKS IN ADVANCE.

 

[CADGemini]

HELLO AGAIN,

WELL I TALKED WITH OUR SUPPORT TEAM AND THEY SAY IT ISN'T POSSIBLE RIGHT NOW IN SOLIDWORKS. HOWEVER THEY MAY BE ABLE TO INCORPORATE SOMETHING IN THE NEXT RELEASE. I SEEM TO GET THAT ANSWER ALOT FROM SOLIDWORKS. DOES ANYONE KNOW OF A WORK AROUND METHOD FOR APPLYING A BI-LATERAL TOLERANCE DIMENSION TO A TABLE? EXAMPLE (+.0001 -.0000) WHERE THE DIGITS WOULD BE STACKED ONE ON TOP OF THE OTHER. HOPE THIS MAKES SENSE.

 

[SBaugh]

Other than manually adding it - There is no other workaround because this is a limitation.

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376